In-House Annual Service

At Eric's Outboard Marine Service we want you to enjoy your time on the water.  This is why our Yamaha Master Certified Technician will check so many different items.  Below is what we check, repalce, and verify on your Annual Service.

4 STROKE 
2 STROKE Carbureted & Fuel Injected



  • Check Engine Compression.
  • Replace Lower Unit Gear Lube.
  • Replace Lower Unit Gear Lube.
  • Remove Propeller, Inspect Propeller, Propshaft and Seal.  Lube Propshaft, Reinstall Propeller and Repalce Cotter Pin.
  • Remove Propeller, Inspect Propeller, Propshaft and Seal.  Lube Propshaft, Reinstall Propeller and Repalce Cotter Pin.
  • Replace Water Pump Impeller and Inspect Related Components.
  • Replace Water Pump Impeller and Inspect Related Components.
  • Replace Engine Primary Fuel Filter.
  • Replace Engine Primary Fuel Filter.
  • Replace Boat Water Separator Filter.
  • Replace Boat Water Separator Filter.
  • Repalce Engine Oil and Oil Filter.
  • Replace Remote Oil Tank Filter.

  • Replace Engine Oil Tank Sight Tube and Check for Water in System.

  • Check Operation of Oil Transfer System and Test Oil Tank Sensors.
  • Repalce Spark Plugs.
  • Replace Spark Plugs.

  • Replace Thermostats
  • Inspect and Replace Zinc Anodes.
  • Inspect and Replace Zinc Anodes.
  • Inspect Timing Belt and Tension.


  • Check for Water Leakage Throughout the Engine.
  • Check for Water Leakage Throughout the Engine.
  • Check Power Trim operation and Top Off Fuild.
  • Check Power Trim operation and Top Off Fuild.
  • Check Battery Condition and Connections.
  • Check Battery Condition and Connections.
  • Inspect Fuel System and Check for Leaks. 
  • Inspect Fuel System and Check for Leaks.
  • Adjust Linkages and Controls.
  • Adjust Linkages and Controls.

  • Adjust Idle Speed
  • Check and Adjust Cowling Latches and Cowling Seal.
  • Check and Adjust Cowling Latches and Cowling Seal.
  • Inspect Steering and Top Off Steering Fluid.
  • Inspect Steering and Top Off Steering Fluid.
  • Top Off Any Other Hydraulic Fluids (Trim Tabs, Power Pole, Jack Plate, etc...)
  • Top Off Any Other Hydraulic Fluids (Trim Tabs, Power Pole, Jack Plate, etc...)
  • Grease Engine at all Grease Points and Spray Other Areas With Corrosion Inhibitor.
  • Grease Engine at all Grease Points and Spray Other Areas With Corrosion Inhibitor.
  • Exterior Inspection of Engine.
  • Exterior Inspection of Engine.
  • Test Run Engine and Check Shifting.
  • Test Run Engine and Check Shifting.
  • Reset Maintenance Interval on Gauge and Note Engine Hours.
  • Reset Maintenance Interval on Gauge and Note Engine Hours.




Click to Email Ryan.