Services

Eric’s Outboard Marine Service

Eric’s Outboard Marine Service, Inc. was founded in 1986, and is now the leading South Florida service center for Yamaha Outboard maintenance and repairs. Our service department offers everything from minor tune-ups, annual services and maintenance to major overhauls performed by Yamaha Certified Mater Technicians.

Our service department is capable of scheduling work here on premises, dockside, and on-site with our mobile technician. If you are not able to bring us the boat yourself, we can arrange for vessel pickup and delivery services. We also handle most plumbing and electrical repairs along with complete installations of electronics and accessories for boats, from bow to stern.

Complete the form below to send us an email!

Service Form

Engine Port

Engine Starboard

Engine Center

Sending

SERVICE DESCRIPTION:

20 Hour (4 – Stroke)

  • Replace gear oil in lower unit
  • Remove prop and inspect prop and propshaft and seal
  • Change engine oil and replace oil filter
  • Replace engine primary fuel filter
  • Replace boat water separator
  • Check for water leakage throughout engine
  • Check power trim operation
  • Check battery condition and connections
  • Adjust linkages and controls
  • Test run engine and check shifting
  • Exterior inspection of engine
  • Check and adjust cowling latches and seal
  • Reset maintenance interval on gauge & note engine hours

ANNUAL SERVICE:

2 STROKE CABURETED AND FUEL INJECTED

  • Check engine compression
  • Replace gear oil in lower unit
  • Remove prop and inspect prop and propshaft and seal.  Lube propshaft
  • Replace water pump impeller & inspect related components
  • Replace engine primary fuel filter
  • Replace boat water separator
  • Replace spark plugs
  • Replace thermostats
  • Inspect / replace zinc anodes
  • Replace remote oil tank filter
  • Replace engine oil tank sight tube and check for water in system
  • Check operation of oil transfer system& test oil tank sensors
  • Check for water leakage throughout engine
  • Check power trim operation and top off fluid
  • Check battery condition and connections
  • Inspect fuel system and check for leaks
  • Adjust linkages and controls
  • Adjust idle speed
  • Check and adjust cowling latches and cowling seal
  • Inspect steering and top off steering fluid
  • Top off any other hydraulic fluids (trim tabs, power pole, jack plate, etc.)
  • Grease engine at all grease points & spray other areas with corrosion inhibitor
  • Exterior inspection of engine
  • Test run engine and check shifting
  • Reset maintenance interval on gauge & note engine hours

2 Stroke, HPDI

  • Check engine compression
  • Replace gear oil in lower unit
  • Remove prop and inspect prop and propshaft and seal. Lube propshaft
  • Replace water pump impeller & inspect related components
  • Replace engine primary fuel filter
  • Replace HPDI filter
  • Replace boat water separator
  • Replace spark plugs
  • Replace thermostats
  • Inspect / replace zinc anodes
  • Replace remote oil tank filter
  • Replace engine oil tank sight tube and check for water in system
  • Check operation of oil transfer system & test oil tank sensors
  • Check for water leakage throughout engine
  • Check power trim operation and top off fluid
  • Check battery condition and connections
  • Inspect fuel system and check for leaks
  • Inspect high pressure fuel pump belt condition and tension
  • Inspect high pressure oil pump operation and hoses
  • Adjust linkages and controls
  • Adjust idle speed
  • Check and adjust cowling latches and cowling seal
  • Inspect steering and top off steering fluid
  • Top off any other hydraulic fluids (trim tabs, power pole, jack plate, etc.)
  • Grease engine at all grease points & spray other areas with corrosion inhibitor
  • Exterior inspection of engine
  • Test run engine and check shifting
  • Reset maintenance interval on gauge & note engine hours

4 Stroke, EFI

  • Replace gear oil in lower unit
  • Remove prop and inspect prop and propshaft and seal.  Lube propshaft
  • Replace water pump impeller & inspect related components
  • Replace engine primary fuel filter
  • Replace boat water separator
  • Change engine oil and oil filter
  • Replace spark plugs
  • Replace thermostats (except on V-6 and V-8 engines)
  • Inspect / replace zinc anodes
  • Inspect timing belt and tension
  • Check for water leakage throughout engine
  • Check power trim operation and top off fluid
  • Check battery condition and connections
  • Inspect fuel system and check for leaks
  • Adjust linkages and controls
  • Check and adjust cowling latches and cowling seal
  • Inspect steering and top off steering fluid
  • Top off any other hydraulic fluids (trim tabs, power pole, jack plate, etc.)
  • Grease engine at all grease points & spray other areas with corrosion inhibitor
  • Exterior inspection of engine
  • Test run engine and check shifting
  • Reset maintenance interval on gauge & note engine hours
adminesolutionsServices